This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. # Heat pumps  --- > “We retrofitted our 17th century cottage with ground-source heating. It was an ambitious project, but in retrospect we are really pleased that we did it. The house is now a steady temperature, with warm floors and no draughts. Once installed, a ground-source heating system is pretty much set and forget.” - Simon Lennane, GP, Ross-on-Wye ## What are heat pumps? A heat pump is simply a device for absorbing heat from one place and transporting it to another. Heat pumps can be used to remove unwanted heat (e.g. a fridge or air conditioning unit) or to transport heat to where it is needed. A fridge is a good demonstration of how surplus heat (from cooling food) can be extracted and redistributed. In fact in a super-insulated home the heat from the back of a fridge or freezer can contribute significantly to space heating. Heat pumps, fridges and air conditioners work on the same principle - [here’s a bit of science](http://home.howstuffworks.com/ac1.htm). An air conditioner takes heat from inside (even if it’s already cold) and dumps it outside. A heat pump does the opposite. In fact if a heat pump is run in reverse it becomes an air conditioner. <WRAP center centeralign> <figure>  <caption> The heat pump itself is the size of a fridge-freezer, with a smaller buffer tank next to it. Image: Simon Lennane </caption> </figure> </WRAP> There are different sources that can be used depending on your property. The most easily installed is the air-source heat pump, which fits to the side of a building and draws in the heat from the air outside. Here's [more information](http://lowimpactorg.onyx-sites.io/info-articles/things-to-think-about-when-considering-an-air-source-heat-pump) on air source heat pumps. A ground-source heat pump requires a more complex system of pipes to be laid in the garden around a property, which means that it costs more, but is more efficient compared to air-source heat pumps. Water-source heat pumps are also available. In each case the system has 3 components: the heat pump itself, plus a collector (outside), and a distribution system (inside). Ground-source heat pumps (GSHPs) rely on heat from the sun warming the surrounding land. In the UK, soil maintains a relatively stable temperature of between 8-12°C at a depth of over a metre, even in winter. <WRAP center centeralign> <figure>  <caption> A (very) simplified diagram showing the layout of a basic ground-source heat pump system. </caption> </figure> </WRAP> The collector or ground loop is simply a closed circuit of pipe, containing a water / antifreeze mix, buried either in a horizontal trench at least 1.2m, but preferably 1.5-2m deep, or in a vertical bore-hole 15-150m deep. The liquid is pumped through the pipes, collecting heat from the surrounding soil, and into the heat pump, usually sited inside the building. The heat pump itself has 3 parts: 1. an evaporator absorbs the heat from the liquid from the ground loop into a refrigerant, then... 3. a compressor compresses to the required distribution temperature, then... 5. a condenser releases that heat into a tank of water feeding the distribution system. Since the heat pump will produce circulating temperatures of only 30-45°C, underfloor heating is best (or highly efficient low temperature radiators), with back-up heating if the system is used for domestic hot water. <WRAP center centeralign> <figure> {{url>https://www.youtube.com/embed/-vU9x3dFMrU 560,315}} <caption> _Excellent explanation of how a heat pump works._ </caption> </figure> </WRAP> Heat pumps are very much in the news these days, as they’re set to replace gas boilers, helped by government incentives. There's been criticism of heat pump technology, but what it really boils down to is that they won’t work as well in badly-insulated homes. The priority for home owners should be to make sure the property is well-insulated first, before installing any renewables. Also, we maybe shouldn't expect to be wearing t-shirts indoors in February; and the technology will improve - in the same way that mpg has improved for cars over the years. ## What are the benefits of heat pumps? Since the heat comes from a renewable source (the sun), heat pumps can help reduce fossil fuel consumption and thus reduce CO2 and other emissions. It must be remembered though, that heat pumps require a reliable electricity supply which may itself come from a non-renewable source. Given that mains electricity is far greener than it was, the saving in CO2 can be quite dramatic. Modern efficient heat pumps can produce enough heat for any household, including hot water. For every 3-4 kW of heat output produced, 1kW of electricity is consumed for the pump and compressor. This is sometimes expressed as being 300-400% efficient, or having a coefficient of performance (CoP) of 3-4. <WRAP center centeralign> <figure>  <caption> Loopy collector pipe for a ground-source heat pump being laid in a trench. </caption> </figure> </WRAP> Running costs are therefore much lower than by direct electric heating. Electric heating is very expensive - the Energy Saving Trust suggest savings of £1000 compared to direct electric heating, and 7 tonnes of CO2 for 100% of space heating and 50% of hot water in a detached property using a 8-12 kW heat pump costing £6000-£12000 (excluding the distribution system). Suggested savings over other fuels are £750 and 1.8T for oil, £350 and 6.5T for solid fuel, £410 and 1.2T for gas. This shows a relatively small financial benefit over gas, so that if a gas supply is available, the cost of installing a GSHP is much less attractive than an efficient gas-fired condensing boiler (at current gas prices). GSHP running costs are also subject to fluctuations in electricity prices. Using onsite PV or wind generation to pump the system would remove this risk and create a more eco-friendly system. Bear in mind that PV may provide very little in mid-winter. <WRAP center centeralign> <figure>  <caption> Air source heat pump. </caption> </figure> </WRAP> Other benefits are high reliability with low maintenance costs and long life expectancy (20-25 years for the pump and up to 50 for the ground loop). There is no local combustion or storage of fuel, and the pump unit only occupies the space of a large domestic fridge. It's quiet and requires no ventilation or flue because it produces no local pollution. Improvements in coolant and refrigerant technology have also reduced the wider impact of these components. <WRAP center centeralign> <figure> {{url>https://www.youtube.com/embed/SSwAhEdUITs 560,315}} <caption> _Installing a ground loop for a heat pump for offices – in Alaska! (Heat pumps really work – even in very cold climates.)_ </caption> </figure> </WRAP> ## What can I do? Look hard at your circumstances. A heat pump could be for you, particularly if: - you are planning a new build or major refurbishment (underfloor pipes or high spec radiators essential). - your property has a very high level of insulation throughout – remember, the heat is distributed at only 30-45°C - some older buildings may not be energy efficient enough. - there is no mains gas supply (financial benefits are much less compared to gas). - you have enough land for a horizontal collector trench - probably at least 2 trenches 300mm wide, 40-50m long and 1.8m deep (or shallower and wider) to take a coiled pipe. - you are on a [green electricity tariff](/grel/green_electricity) (this enhances the environmental benefits). - you can include onsite electricity generation (e.g. [pv](/soel/solar_electricity) or [wind](/wind/wind_generators)) to power the pump. <WRAP center centeralign> <figure>  <caption> Ground-source heat pumps produce low-level heat that is ideal for underfloor heating. Image: Simon Lennane </caption> </figure> </WRAP> On densely-built city sites with little land, vertical boreholes from mini-sized drilling rigs are the efficient solution. Vertical boreholes can be charged with heat from solar panels, pumping heat deep down for recovery in winter. Get professional advice. System design is crucial for GSHPs. This is very project-specific as required output is calculated from the property’s demand (heat loss, water use etc), and collector length matched to output. An oversized heat pump will cost more for no additional benefit, and possibly suffer reduced equipment life and operating efficiency due to frequent cycling. Under-capacity may require more top-up heating. <WRAP center centeralign> <figure>  <caption> Water-source collector loops being lowered into a pond. Image: [Mark Johnson](https://commons.wikimedia.org/wiki/File:Pond_Loop_Being_Sunk.jpg) at [English Wikipedia](https://en.wikipedia.org/wiki/Main_Page) </caption> </figure> </WRAP> Heat pumps are going to become the default for new builds. It’s much cheaper and easier to install than to retrofit, and provides a very low-maintenance way of generating heat from pure renewables. Using nearby parks or green spaces would be an ideal way of mixing natural space and renewable heating. If there isn’t space for a horizontal underground collector system, the air source or vertical borehole options could be considered. Our friend Simon shares his experiences of [installing a ground-source heat pump](http://lowimpactorg.onyx-sites.io/converting-to-ground-source-heating-simon-lennane/) in an old cottage in Herefordshire. NB: you can [apply for up to 100% funding](https://app.convertcalculator.co/to/jAfjwctzALQH59TyF) for an air source heat pump installation from our partners Housewrapped. ## Further resources - [Find an installer](https://mcscertified.com/find-an-installer/) - [Energy Saving Trust](https://energysavingtrust.org.uk/advice/ground-source-heat-pumps/) - information on heat pumps, including grants & incentives - [European Heat Pump Association](https://ehpa.org/) - [Ground Source Heat Pump Association](https://gshp.org.uk/) - [Heat Pumping Technologies](https://heatpumpingtechnologies.org/) - international information service for heat pumping technologies - [International Ground Source Heat Pump Association](https://igshpa.org/) - [Heat pump information](https://heatpumps.co.uk/) - [UK Heat Pump Association](https://www.heatpumps.org.uk/) ## Specialists heat/heat_pumps.txt Last modified: 2025/12/09 12:10by dave